Huatao Group-Vibrating Screen Technology Solution and Service for Quarry & Mining Industry Since 2008.
Capture of tramp iron is governed by the competition between magnetic force pulling a particle toward the magnet face and the combined forces of belt speed, material burden weight, and ore-to-particle friction. Magnetic force scales with the product of field strength and field gradient. Ceramic magnets produce a moderate field that decays quickly with distance, which is acceptable for a 200 g bolt but inadequate for a 0.5 mm steel sliver buried under 150 mm of ore. Rare earth magnets produce both higher field and — critically — a steeper gradient at the pole edges, which is what actually grabs fine particles. This is why a rare earth Self-Cleaning Electromagnetic Separator or permanent rare earth unit can hold a fine wire against a moving belt while a ceramic unit of the same physical size lets it release and re-enter the stream. The self-cleaning belt then does the second half of the job: it must drag captured iron out of the field quickly, because any particle that stays on the magnet face builds up a cascade that eventually blinds the discharge.
On a typical gold plant conveyor system, magnetic protection appears at three points, and the ceramic-vs-rare-earth answer differs at each one.
Rom and primary feed belts. The contamination here is coarse — drill steel, bucket teeth, liner bolts. A ceramic self-cleaning unit or an Electromagnetic Overband Separator handles this economically, because deep-field fine capture is irrelevant when the danger pieces weigh kilograms.
Secondary crushing feed and transfer conveyors. This is the fine tramp iron zone: screen cloth fragments, wire pieces from self-cleaning screens, drill fines. A rare earth unit earns its premium here, protecting cone crushers and keeping steel out of the grinding circuit where loose steel damages mill internals and dilutes grinding performance.
Pre-concentration and tail-end conveyors ahead of gravity recovery. Steel fragments in feed to shaking tables, jigs or centrifugal units abrogate concentrate quality and can wedge in concentrate launders. Plants running Gold Recovery Equipment or a Gold Centrifugal Concentrator typically specify rare earth capture on these belts, since a single steel sliver trapped in a concentrate bowl costs more to diagnose than the magnet premium.
Customer Type: mid-size gold ore processing plant, gravity-flotation circuit.
Ore Type: free-milling gold ore with quartz gangue, above-average steel contamination from old underground workings.
Operating Conditions: 1,200 t/d, 1,050 mm belt at 1.8 m/s, 120 mm suspension gap, ore temperature up to 65 °C in summer.
Problem: the plant ran a ceramic self-cleaning magnet sized for coarse protection, yet cone liners were being damaged 2–3 times per year by fine steel fragments — mostly screen wire and drill-steel filings. Manual metal detection stoppages averaged 12 per month.
Solution: replaced the ceramic assembly with a rare earth (SH-grade, 100 °C margin) self-cleaning unit at the same suspension point, and re-set the discharge chute to 12 mm clearance. Existing Belt Cleaner and conveyor components were retained.
Result: fine-iron capture mass on the discharge increased about 3×, crusher damage events fell to zero over the following nine months, and metal detector stoppages dropped by roughly 70%. The magnet premium was recovered in avoided crusher relines within one operating quarter.
The ceramic-versus-rare-earth decision for a self-cleaning magnetic separator on a gold ore conveyor comes down to one honest question: what is the real size of the steel you need to stop? Ceramic remains a rational, economical choice for coarse tramp iron on low-speed, thin-bed conveyors, and its price stability is a genuine advantage in the 2026 NdPr market. But when the documented damage is being done by fine tramp iron — screen wire, filings, slivers — no amount of ceramic strength compensates for physics; the gradient that captures sub-millimeter particles exists only in rare earth pole geometry. Measure your contamination, state your temperature, model your gap and speed, and buy the magnet that captures the particles that actually hurt your circuit. For buyers planning a full conveyor or screening upgrade, the same logic chain connects through Magnetic Separators, Conveyor Belts and screen media selection — the weakest component still sets the protection level of the whole line.
Related Products
Related Technical Guides
Related Buyer Guides
Related Comparison Articles
Contact: Annie Lu
Email: annie.lu@huataogroup.com
Phone / WhatsApp: +86 180 3242 2676
Website: http://www.tufflexscreen.com
We warmly welcome customers from around the world to contact us and establish mutually beneficial partnerships.
Contact: Annie Lu
Tel: +86 18032422676
E-mail: manager11@huataogroup.com
Address: Zhonghua North Street, Shijiazhuang, Hebei, China