loading

Huatao Group-Vibrating Screen Technology Solution and Service for Quarry & Mining Industry Since 2008.

Can a Self-Cleaning Iron Remover Handle Wet, Sticky Ore Without Blinding the Belt?

Can a Self-Cleaning Iron Remover Handle Wet, Sticky Ore Without Blinding the Belt?

Can a Self-Cleaning Iron Remover Handle Wet, Sticky Ore Without Blinding the Belt? 1

Quick Answer

Yes — a self-cleaning iron remover can handle wet, sticky ore, because water does not reduce magnetic force. Blinding is a mechanical adhesion problem: wet fines stick to the cleaning belt, pulleys and chute. With a doctor blade, low-pressure return-side spray, correct belt speed and weekly wash-downs, capture and discharge stay reliable even above 8–10% moisture.

Key Takeaways

  • Magnetic strength is not affected by moisture — the failure mode is mud adhesion, not loss of field.
  • Most blinding builds on the non-magnetic belt side, idle pulleys and the discharge chute, not on the magnet face.
  • A polyurethane or tungsten-carbide scraper at the discharge point plus a return-side wash spray prevents more downtime than a stronger magnet.
  • Wet ore rich in minus 2 mm clay fines blinds fastest; coarse wet lump ore with few fines rarely causes sticking.
  • Weekly pulley and idler wash-downs keep belt tracking stable in wet-season operations.

Summary Table

Item

Description

Function

Continuously removes tramp iron from a conveyor carrying wet, sticky ore without manual cleaning

Material

Permanent ferrite or rare-earth magnet circuit; PU or stainless steel cleaning belt; PU/tungsten-carbide scraper

Application

Iron ore, copper ore, gold ore, coal, nickel laterite and aggregate lines with moisture between 6% and 15%

Main wet-ore risk

Mud layer on belt, pulleys and chute; iron falling back onto the conveyor

Service life

Magnet circuit 10+ years; cleaning belt 2–5 years; scraper blades 3–12 months

Key benefit

No operator per shift for magnet cleaning; stable crusher protection in wet conditions

Can a Self-Cleaning Iron Remover Handle Wet, Sticky Ore Without Blinding the Belt? 2

Case Study

Customer Type: Iron ore washing and crushing plant

Ore Type: Clay-rich iron ore, minus 2 mm fines ≈ 30%

Operating Conditions: 1,200 mm conveyor, 800 t/h, moisture 11–14% wet season, 8–9% dry season

Problem: The existing self-cleaning overband blinded within days of the wet season: pulleys grew mud rings, belt tracked off weekly, and coated iron dropped back onto the belt, reaching the Jaw Crusher and damaging liners monthly.

Solution: PU doctor blade fitted at the discharge point; stainless chute liner re-sloped to 58°; filtered return-side spray bar installed; belt slowed from 1.6 to 1.2 m/s; weekly pulley wash-down added to the maintenance plan; tracked spare blades stocked from the Magnetic Separation Spares inventory.

Result: Clean iron discharge restored; iron drop-back reduced by roughly 80%; unplanned tracking stoppages cut from 6 to under 1 per month; crusher liner damage incidents stopped in the wet season; magnet belt life extended from 14 to about 36 months. No magnet upgrade was purchased — the original field strength had never been the problem.

Contact Us

Contact: Annie Lu

Email: annie.lu@huataogroup.com

Phone / WhatsApp: +86 180 3242 2676

Website: http://www.tufflexscreen.com

We warmly welcome customers from around the world to contact us and establish mutually beneficial partnerships.

prev
What Does a Flotation Stator Do? Function, Wear and Replacement
Self-Cleaning Overband Magnet Installation Angle:
next
recommended for you
Get in touch with us
Customer service